WARNING: Exposure to UV light could burn the skin and can cause severe and permanent eye damage by burning
the retina. Do not look directly at the UV light.
WARNING: Before replacing the UV lamp, make sure the power
source is disconnected or turned OFF.
NOTE: Do not touch the glass portion of the germicidal UV lamp with bare hands. Use cotton
gloves to avoid skin oils that will harm the UV lamp.
NOTE: Use only original American-Lights® UV lamps. Other lamps
will be incompatible and may damage the air cleaner.
NOTE: American Air & Water®, Inc. highly recommends that a qualified
technician performs the germicidal UV lamp replacement. The UV lamp should be
replaced as follows:
UV lamp replacement with retaining clip - Lamp model AAWHO/14
- Remove the 2 Philips screws on the top of the cover and remove the American-Lights® cover.
- Unplug the UV lamp power plug.
- Loosen the retaining lamp clip fasteners and slide clip into open position.
- Carefully pull out the old UV lamp by holding the lamp base.
- Using gloves slide the new UV lamp through the hole in the unit
and duct until the retaining ring will not allow further insertion. Slide
retaining clip over retaining ring and tighten the fasteners so it will not move.
- Carefully attach the plug to the 4-pin end of the UV lamp.
- Replace the cover and tighten the screws. Do not pinch or cut any wires.
- Power the UV air cleaner. The UV lamp will come on instantly.
IMPORTANT: Dispose of the old UV lamp as a hazardous
waste in accordance with local, state and federal regulations or the lamp
should be recycled. Please dispose of the used UV lamp properly or send it to
American Air & Water for recycling.
Print Instructions
UV lamp replacement with adjustable coupling - Lamp
model UVHOAL300AV/14
- Remove the 2 Philips screws on the top of the cover and remove the American-Lights® cover.
- Unscrew the adjustable coupling and gently pull the old lamp until it is free from the coupling.
- Carefully unplug the UV lamp power plug.
- Carefully pull out the old UV lamp by holding the lamp base.
- Using gloves, replace the UV lamp into the coupling. Reconnect electrical connection and gently tighten. NOTE: Over-tightening could cause system damage.
- Replace the cover and tighten the screws. Do not pinch or cut any wires.
- Power the UV air cleaner. The UV lamp will come on instantly.
IMPORTANT: Dispose of the old UV lamp as a
hazardous waste in accordance with local, state and federal regulations or the
lamp should be recycled. Please dispose of the used UV lamp properly or send
it to American Air & Water for recycling.
Print Instructions